Simpler Networks HP200PT64 Instrukcja Użytkownika Pobierz pdf (Strona 20)

Available Connections

PLC Connections

The total number of PowerGrid units in the network.

PLC PORT

The PLC data connection port for each connection.

MAC Address

This is a code that identifies all remote devices

connected to this unit. On PowerGrid units, it is printed

on the back label under the barcode.

Phy Tx/Rx Throughput

Physical Transmission / Reception Throughput is a

measure of network bandwidth. Available data

transmission capacity is roughly half this value.

Bridge State

Enabled indicates there is a data connection.

Disabled indicates no data connection.

Network Id

Network ID is used for network security. If present, it

means the remote device is on the same network.

External Interfaces

Interface

EXTA = Ethernet

Phy Throughput

Physical Throughput = Data Transmission Capacity

Bridge State

Forwarding = Active

General Information

MAC Type

The MAC Address shown above is an In-Home AV type.

MAC Address

This code identifies the PowerGrid unit that is currently

being managed with the WUI. The MAC Address is

printed on the back label of the unit, under the barcode.

IP Address

The IP Address defines the location of the PowerGrid

unit on the local area network.

Node Type

This will show as Fixed AP, EP or AP.

Number of Boots

The number of times this PowerGrid unit has been

rebooted since the last Factory Reset.

NOTE: The remaining fields are advanced settings used for technical support.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 40 41

Brak uwag

Simpler Networks HP200PT64 Instrukcja Użytkownika Strona 20